These Key Blocks are a modular snap-together set of key holders which allow you to store or hang your spare keys in an organized and adaptable way. In addition to the key holders themselves, I have made some “ends” which allow you to add a hook, ring or stand so that you can store the assembled set however suits you.

My original plan was to hang them in a closet but I quite like the idea of a small stand on my desk for the keys I need more often. And, I have also made a ring end that can hang onto any kind of hook. I will use this for storing keys in my vehicle as well as the hook makes it easy to grab ahold of.

Each Key Block has a set of flexible ribs which grip the end of any key inserted into it.

Printing

I have tried to make my main print settings visible on the Cura screenshot but in case they are difficult to read I have summarized them again here…

Material: I choose to use PETG for its durability and flexibility.

My Setup:
Nozzle = 0.4mm

My Settings:
Layer height = 0.2mm
Line width = 0.4mm
Wall count = 4 (1.6mm)
Infill = 40%
Ironing = OFF

Support:
Designed to print without support. Only the ring end has a built-in print support which you will need to remove after printing.

Print Orientation: As shown in the screenshot(s).

Assembly Notes

No assembly or post-print processing is required except the removal of the print support from the ring end.

The post Key Blocks first appeared on logicalplanet.