Click here to download STL (Affiliate Link)

It is a super simple 1-piece print. And, it attaches by simply placing it behind a wall plate. The existing wall plate screws hold the wall plate and the Mini eShelf in place with considerable strength. Definitely adequate enough for small electronics or similar.

A complication I discovered after designing my first one and getting a few followers to test it was, not all wall plates are the same size. So I have created a few size variants to hopefully allow it to work for most people.

On the top back centre of the shelf is a recess (pass through hole) so that electrical wires can be container when using the Mini eShelf for charger or similar activities.

Print Settings

Functional designs (such as this one) generally require more strength than non-functional designs and more strength than the typical default slicer settings provide, so please review your slicer settings carefully.

This product was designed for a 0.4mm nozzle and a 0.2mm layer height. For best results, I suggest the following:

Assembly and Installation Notes

No assembly is required. It is ready to go right off the print plate. And, installation is a breeze. Simply unscrew your existing wall plate and then place the Mini eShelf behind it. Screw the original wall plate back into place. That’s it!!

The post Mini eShelf first appeared on logicalplanet.