As you can see from the animated gif images, there is considerable water leaking out from the mechanism because of the rough 3D-printed surfaces. I found that acceptable under the circumstances but one could probably reduce that if some time was spent on it.

The following diagram illustrates all the components and their relationships. Assembly is straight forward and no screws or fasteners are needed. I do recommend some garden hose washers (gaskets) as shown.

The water pressure from the hose will push the pedal up and then an pressure down on the pedal releases the flow of water up and out the fountain head. The following images try to illustrate that.

The main body prints standing on end with print support incorporated as show below.

The floating female hose connector might bind a little and needs to be coerced into free rotation as illustrated below.

The post Step Fountain for Bob first appeared on logicalplanet.