Simply screw it to your wall or cabinet and hang pot lids in it. The lids must have an inside edge like glass lids typically do. Some metal lids do and some don’t – so be sure to check out your lids before printing this.

The Lid Hanger is very strong and will easily handle the weight of 4 lids. I would be happy to make it in other sizes if anyone wants it bigger or smaller.

Hanging and removing lids in the hanger is very easy but does require you to slow down a little so that you do not knock off other lids as you insert or remove a lid.

Printing

I have tried to make my main print settings visible on the Cura screenshot but in case they are difficult to read I have summarized them again here…

Material: I chose to use PETG.

My Setup:
Nozzle = 0.4mm

My Settings:
Layer height = 0.2mm
Line width = 0.4mm
Wall count = 4 (1.6mm)
Infill = 40%

Support:
Designed to print without support.

Print Orientation: As shown in the screenshot(s).

Assembly Notes

No assembly or post-print processing is required. Just screw it to a wall or cabinet.

The post Lid Stack Hanger first appeared on logicalplanet.