Quick Release Fan Duct For JG Aurora A5S)

Paul Brock — Sat, 02 Jan 2021 23:15:00 +0000

This is one of those projects that I spent a ridiculous amount of time on and in the end really never finished it. The idea is fantastic though… snap on and off fan ducts for the hotted on a JG Aurora A3S or A5S. Not only does it make replacement quick and easy, but the real excitement is also being able to swap different kinds of fan ducts for experimenting.

^{Mount attaches to print head}

^{Fan duct snaps into mount}

I am posting it here now basically as a “food for thought” kind of project. Up until now at least I have not seen any other quick-release fan ducts. And, that may be because there isn’t a great need. But nonetheless, the idea is interesting to me.

In the very end, my conclusion was that in fact the airflow and direction are less important than the amount of airflow. And, as a result, I used these designs but did not do much swapping of the fan duct once I got my printer “dialled in”.

The post Quick Release Fan Duct For JG Aurora A5S) first appeared on logicalplanet.

A3S Cable Chains

Paul Brock — Fri, 01 Nov 2019 16:59:02 +0000

I designed this from the ground up as a learning exercise as much as anything else. And, honestly just because it seemed like a fun project. I had no cable chain experience before making this so I am not sure exactly how the chain is supposed to behave but I think this one works pretty well.

This cable chain is really not needed but I didn’t like the way the x-axis motor wires rubbed up against the hotbed and sometimes the hotbed connector. The cable chain positions the wires away from the hotbed and controls its position at all times to avoid any conflict with the bed, bed connector or printed parts.

^{Before Cable Chain Added}

^{After Cable Chain Added}

The assembly uses existing screws on the printer to hold everything in place. So no new hardware is needed.

I was having a lot of difficulty printing the very small overhangs used on the rounded edges of the parts. So I added a small wedge to serve as support which worked well but has to be clipped off with side cutters after printing. So I am including two sets of everything. One set has the support wedges and one set does not (for those who can print overhangs well).

The cable retaining clip that snaps into place after the wire is laid into the chain is designed to be snapped in and out relatively easily but they are small so hopefully you never need to take them out. If you do need to take them out pry under them with a small screwdriver or similar and it will pop out.

The JGAurora A3S uses 13 links plus the upper and lower attachments. I am pretty sure this will work on the A5 as well but will require more links (17 or 18 links).

Post-Printing

1. Remove the supports (if you printed the version that has supports)

Use your diagonal cutters (if you don’t have any get some, best $10 you will ever spend) to clip off the small support I placed under the front and back edges. See photo…

2. Snap together

The links are designed to snap together with the inner link sliding into the outer link from the top. There are recesses in the inner side of the outer link to allow them to snap together with less stress.

3. Install on the printer

Before you start move the z-axis up to half height or higher. And, move the print head along the x-axis away from the x-axis stepper motor.

Remove the screw under the x-axis stepper motor and then re-install the screw through the top of the assembly as shown in the photo.

Remove the screw holding the x-axis wiring strain relief at the bottom (see photo) and re-install the screw (without the washer or strain relief) through the lower part of the assembly under it.

4. Load the cable and snap in the retainers

Position the x-axis cable into the cable chain trays and then place a clip onto each of the links.

Go print!

The post A3S Cable Chains first appeared on logicalplanet.