The design is about 240mm across which is a fair-sized print. At that size, it will hold about 150 small candy bars. But you can scale it up or down depending on your printer size and your needs.

I would be cautious to scale it up too much though as the print duration will start to get significant (already about 10 hours on my BambuLab X1). And, I think at 240mm it is already big enough!

The bowl itself has a smooth inside surface which hides a fairly thick wall structure so I suggest printing with 2 lines width walls and about 15% infill is a nice strength-to-weight ratio.

Printing

This pumpkin bowl does not require much functional strength therefore your default slicer settings should work well. I do not recommend using vase mode as that will be too weak.

This product was designed for a 0.4mm nozzle, a 0.2mm layer height and the following settings:

• Wall Line Count (minimum) = 2 ( 2 x 0.4mm = 0.8mm walls )
• Top & Bottom Layer Count (minimum) = 3 ( 3 x 0.2mm = 0.6mm top & bottom )
• Infill = 15%, Cubic
• Ironing = No
• Support = None required
• Brim = NO
• MATERIAL: PLA

Assembly Notes

No assembly or post-print processing is required.

The post Large Pumpkin Treat Bowl first appeared on logicalplanet.