Stick-on FlexPlate

This is an extension of my wallplatemate system. See wallplatemate.com for more product information.

I have created a stick-on version of the WallMatePlate FlexPlate (p/n FP1) which is an alternative to the original screw-on version (p/n FP0). This new stick-on version is designed to use 19mm (0.75″) wide double-sided adhesive to attach the FlexPlate to the wall thereby avoiding the use of screws and marking up the wall.

I recommend using 3M Command Strips or something equally as good. I am sure everyone knows by now, but just in case you do not, the 3M Command Strips allow you to easily remove the double-sided adhesive from the wall whenever you choose. And, they seem to provide exceptional adhesion strength in all the circumstances I have used them for in the past. But make sure you clean the wall before applying the adhesive.

Printing

To improve the adhesion of the double-side adhesive tape to the top of the print I strongly recommend turning on ironing.

I have tried to make my main print settings visible on the Cura screenshot but in case they are difficult to read I have summarized them again here…

Material: I choose to use PETG for its durability and flexibility.

My Setup:
Nozzle = 0.4mm

My Settings:
Layer height = 0.2mm
Line width = 0.4mm
Wall count = 4 (1.6mm)
Infill = 40%
Ironing = ON

Support:
Designed to print without support.

Print Orientation: As shown in the screenshot(s).

Assembly Notes

No assembly or post-print processing is required.