Free to download on thangs.com from July 5 to July 11, 2024
Another design made at my wife’s request… she saw something like this at a friend’s house and asked me to make it. It is a hook onto the tank spare toilet paper holder so you always have a backup ready. Especially good for any washroom used by guests since they may not know where to find the spare TP. This one works super well and I believe will work on any tank.
Not a whole lot more needs to be said, it just rests on the lip of the tank and you drop on a roll of paper. I designed this based on the very large Costco Kirkland branded rolls so I am pretty sure it will fit and other sizes out there.
Printing
I have tried to make my main print settings visible on the Cura screenshot but in case they are difficult to read I have summarized them again here…
Material: Because it is exposed to water I recommend using PETG but I think any material will work fine.
My Setup:
Nozzle = 0.4mm
My Settings:
Layer height = 0.2mm
Line width = 0.4mm
Wall count = 4 (1.6mm)
Infill = 40%
Ironing = Not important.
Support:
Designed to print without support.
Print Orientation: As shown in the screenshot(s).
Assembly Notes
No assembly or post-print processing is required.
Leave a Reply