Similar to my 1060 series cases, these cases are modular and many of the parts are interchangeable. All components are printed (no screws, pins or other hardware needed). The parts snap together and make a fairly durable case of random things.
These all have an inside width of 20mm. The lengths vary including an 80mm, 90mm, and 120mm. The height is depending on each design mainly 40mm, 60mm, and 110mm (inside; not including lid). The lids are all 10mm high.
After each iteration of design I slowly refined the one I wanted to use at 20×090 x60 High. With a card slot. This became the model my wife used to carry a mask and a few credit cards when she went out. But you can use them for whatever you want. All the sizes are very functional.
The hinge and latch are the same for all (interchangeable). They are also the same as my 1060 series cases.
Hopefully, the file names are intuitive enough to see what part is what.
Assembly note(s):
Take note that the hinge should be snapped in with the spine or back of the hinge against the body and lid. In other words, the openings on the hinge should be facing out once assembled. The hinge and the clasp can go on either side.
Leave a Reply